Descargar Imprimir esta página

MiLECTRIC ARC-N01 Manual De Instrucciones página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Insert the plug into the wall socket and switch on the electricity supply,then the Red light is on. Avoid accidental
disconnection by taping over the switch. Green light will glow and the compressor will start running.
4. You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also
give rise to noise, whether the compressor is running or not which is quite normal.
5. If you going to store already frozen food open the freezer lid and check that the freezer has reached the correct
temperature. Then you can put in your already frozen food.
6. Do not load the appliance immediately after it is switched on. Wait until the correct storage temperature has been reached.
We recommend that you check the temperature with an accurate thermometer.
Important Notes:
• If there is a power failure do not open the lid. Frozen food should not be affected if the failure lasts for less than 20
hours. If the failure is longer, then the food should be checked and eaten immediately or cooked and then refrozen.
• If you find that the lid of the chest freezer is difficult to open just after you have closed it, don't worry. This is due to the
pressure difference which will equalize and allow the lid to be opened normally after a few minutes.
FREEZER OPERATION
The inside temperature of freezer is regulated by thermostat adjustment knob.
"1,2,3,4,5,6,7"marks on the knob do not represent the exact temperature, but show that the smaller number represent the
higher the temperature, conversely, the bigger number, the lower the temperature.
The following figure illustrates information as below:
"1(Refrigerator) ": Temperature range(5℃)
"2-4 (Freezer)":Temperature range(-12~-18℃)
"4-7(Freezer)":Temperature range(-18~-24℃)
"7 (Fast freezer )": Temperature range(below-24℃)
There is a deviation of ±3℃ for each mode in different usage environments due to the mechanical control mode.
Please make fine adjustment according to the actual use condition.
Fast freezer (below -24℃):While set the knob to fast freezing range, please keep the compressor continuous operating
without stopping, the food can be quickly cooled.
Caution: Do not keep the knob on the fast freezing position after fast freezing
Refrigerating mode:
When change the refrigerating status to others, you should take out food to avoid them being frosted damaged. If shift
freezing or soft freezing satus to refrigerating mode, you should take the following steps:
Set the knob of thermostat to refrigeration mode, then remove all of frozen food from freeze compartment, then keep it being
empty for one hour, and finally put the required food into it.
Due to individual factors of the refrigerator, the actual temperature in the box may have a certain error from
the set temperature, which is a normal phenomenon and does not affect the normal use of the product.
STORING FROZEN FOOD
Prepackaged commercially frozen food should be stored in accordance with the frozen food manufacturer's instructions for a
freezer compartment.
To ensure that the high quality achieved by the frozen food manufacturer and the food retailer is maintained the following
should be remembered:
1.Put packets in the freezer as quickly as possible after purchase.
2.Do not exceed "Use By", "Best Before" dates on the packaging.
FREEZING FRESH FOOD
Place fresh food to be frozen near the side walls to ensure fast freezing and away from already frozen food, if possible.
Never exceed this maximum capacity. Do not freeze too large a quantity at any one time.
The quality of the food is best preserved when it is frozen right through to the centre as quickly as possible.

Publicidad

loading

Este manual también es adecuado para:

Arc-n51Arc-n02844563900139484456390014008445639001417