Descargar Imprimir esta página

Orking Instructions; S Witching On/Off; P Reventive Maintenance; R Epair - SUHNER ABRASIVE WB 7 Documentación Técnica

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDLINg
3.1 w

Orking instructiOns

To achieve an optimum grinding result, move
grinding belt uniformly back and forth with light
pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding belt.
3.2 s
On/Off
witching
Hold the hand tool firmly.
Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding belts.
You must always hold the hand tool when it is operating.
Switch off the drive when you stop working.
The tool still needs time to stop after the machine has
been switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4. S
ERvICE
4.1 p
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place.
As soon as contact rollers show signs of wear they
must be replaced.
Damaged guards must be replaced.
4.2 r
epAir
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w

ArrAnty

In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
tOrAge
24
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
/o
PERaTIoN
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
must be disposed of in an environmentally-compatible
recycling process.
/m
aINTENaNCE
/ e
ispOsAl
nVirOnmentAl cOmpAtiBility
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool

Publicidad

loading