Night Mode - Atlantis SOPHIA Manual De Uso

Instructions for use
Press the side button for 3 seconds to turn on the light.
Press the side button for 1 second to change the lighting mode:

1. NIGHT MODE:

The sensor will emit a blue light flashing 6 times. Once this mode is activated, the light will
only turn on at night. It will not turn on during the day.
2. DAY MODE:
The sensor will emit a red light flashing 6 times. Once this mode is activated, the light will
only turn on when motion is detected.
3. FIXED MODE:
The sensor will not emit any light. Once this mode is activated, the light remains steady
and can be used as a torch.
Press the side button for 3 seconds to turn the light o .
Charging
Connect the micro USB charging cable included with the product to a computer or power
source with a USB A port.
Di erent lights will illuminate depending on the charging status:
• Charging: a steady red light will illuminate.
• Charging complete: the steady red light will change to blue. This indicates that charging
is complete.
• Low current protection: if the voltage connected to the light is below 2.7V, the red light
and blue light will flash 6 times at the same time and the light will turn o .
Installation
• Secure the 2 metal parts with adhesive on the back of the strip designed for this purpose
(they should be fixed like magnets).
• Find a flat surface and clean that area for better adhesion.
• Carefully remove the protective film from the adhesives on both metal parts and attach
the light to the desired surface.
• Separate the light from the metal parts to charge the light, clean it or transport it as a
torch.
Safety precautions
1. This product is powered by rechargeable battery.
2. Do not install this product in damp locations.
3. Do not expose the product to high temperatures or direct sunlight. It may a ect the
proper operation of the product.
4. Do not install two lights too close together. The illumination of one light may a ect the
operation of the other light.
5. Keep the product away from fire and water to avoid the risk of leakage or explosion.
Maintenance recommendations
• Regularly clean the product with a dry cloth. The product must be disconnected or
switched o when you clean it.
• Keep the connectors and/ or ports free from dust, lint, etc. to prevent improper
connections.
• Avoid breaking the device. Do not put objects over it or bend it too strong.
• If the product includes a cable do not bend it too strong and do not pull from it to
unplug the product.
• Do not wet the product. Keep it always in a dry place, away from humidity.
• When not using the product, store it in a place free from dust, dirt, lint, liquids, etc.
• If water or other liquids enter the product interior, unplug it immediately from any
attached power source or device it is connected to.
• Avoid dropping or hitting the product. It might be damaged.
• Do not use the product for anything other than its intended use.
• Please recycle the product in accordance with local environmental laws and regulations.