Descargar Imprimir esta página

Qilive Q.6257 Manual Del Usuario página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
Sleep mode ( ): The fan runs at the set speed initially, then the speed automatically
changes to a next lower level every 30 minutes until the lowest speed level is reached.
The fan remains on unless it is switched off manually or by a switch-off timer.
5.6
Set switch-off timer
You can set a timer at which the fan will automatically turn off.
When the fan is on, press
to select a timer (up to 8 hours can be set). The timer is set after the set time
indicated by "h" flashes five times and disappears on the control panel (13). Then
the current speed level is displayed on the control panel (13)
5.7
Set switch-on timer
You can set a timer at which the fan will automatically turn on.
When the fan is off, press
to set a timer (up to 8 hours can be set). The set time indicated by "h" is displayed
on the control panel (13).
5.8
Temperature controlled fan speed
When this function is activated and the ambient temperature is detected above 24°C, the
fan automatically changes fan speeds by detecting changes of the ambient temperature.
Note: If this function is activated and the ambient temperature is detected below or equal
to 24°C,the fan will operate at speed 1.
To activate or deactivate the function, press
and - on the remote control).
If the function is activated, the display on the control panel (13) always shows the
current ambient temperature indicated by °C symbol. If the function is deactivated,
no temperature is displayed.
5.9
Fan head adjustment
Turn the fan head upwards or downwards to adjust angle of
airflow.
5.10 Replacement of remote control battery
The remote control is powered by a CR2025 button cell. Replace the battery when the
battery depletes.
Find the battery compartment door on the back of the remote control. Press and
hold the tab (A) and simultaneously pull the battery tray out (as shown in the figure
below), and place a new CR2025 battery in the battery tray with correct polarity
indicated, then close the battery tray.
1
A
on the control panel (13) (or
on the control panel (13) (or
2
on the control panel (or hold down
10
on the remote control)
on the remote control)

Publicidad

loading