ASSEMBLY INSTRUCTIONS
1.
Attach the Circular Cubby (C) to the Bottom Platform (A)
using the Short Hardware Screw with Plastic Cap (B).
Use the Allen Wrench (U) to tighten. NOTE: Attach to
the hole closest to the center of the Bottom Platform.
2.
Insert the LONG threads of the Dual Threaded Screw (D)
into the Long Sisal-Wrapped Tube (E). Use a Flathead
Screwdriver to tighten. Then, screw the Long
Sisal-Wrapped Tube into the Bottom Platform.
NOTE: The SHORT threads go down into the Platform.
Attach the Sisal-Wrapped Tube (H) to the Circular Cubby
3.
using the Long Hardware Screw with Washer (G). The
washer should be placed on the screw before inserting
the screw up through the top of the Cubby. Use the Allen
Wrench (U) to tighten.
4.
Insert the threads of the Dual Threaded Screws with Even
Threads (I and K) into the Sisal-Wrapped Tubes
(E and H) until the threads disappear. Do NOT tighten all
the way.
IMPORTANT NOTE:
SHORT threads go
down into the base.