Descargar Imprimir esta página

Wall Installation - Yale PWLCL630SS Guía De Instalación, Uso Y Mantenimiento

Ocultar thumbs Ver también para PWLCL630SS:

Publicidad

Idiomas disponibles

Idiomas disponibles

4 Flip the blower base to the rear face of the range hood.
5 Insert the two blower springs to the top of the range hood
housing, Secure it with the four mounting screws previously
released.

Wall Installation

I
WARNING
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL RANGE
HOOD. FAILURE TO DO SO CAN RESULT IN BACK OR OTHER
INJURY.
IMPORTANT: Framing must be capable of supporting up to
150 lbs.
The hood is attached to the wall with the wood support that is
attached to the back of the hood.
• Determine and mark the centerline on the wall where the
canopy hood will be installed.
• Select a mounting height "X".
For gas cooktop & range installations: Mount the hood so the
bottom is at least 30" (76.2 cm) above the cooking surface.
For electric/induction cooktop & range installations: Mount the
hood so the bottom is at least 24" (61 cm) above the cooking
surface.
• Mark a horizontal reference line on the wall.
• Remove the wood support from the back of the range hood by
loosening the 2 screws from the inside. Locate and level the
top of the wood support 15 ³⁄
horizontal line and centered on the vertical centerline. Using 2
of the 4 of the 6 x 80 mm screws, install wood support so that it
is screwed into at least 2 vertical studs.
• Leave a
" (6.4 mm) gap between the wall and the back of the
1
4
screw head to slide range hood into place.
"
1
4
(6,4 mm)
" (39.1 cm) above the marked
8
15
"
3
8
(39 cm)
"x"
D
A. Wood support
B. Bottom of range hood
C. Centerline
D. Dimension "X" = range hood mounting height
NOTE: The screws provided for mounting this range hood must
be fastened into solid wood; do not fasten into sheetrock only.
Complete Preparation
1 Determine and make all necessary cuts in the wall or roof for
the vent system. Install the vent system before installing the
range hood. See the "Venting Methods" section.
2 Determine the location where the power supply cable will be
run through the wall or the roof.
3 Drill a 1
" (3.2 cm) hole at this location.
1
4
4 Pull enough power supply cable through the wall to allow for
easy connection to the terminal box.
5 Remove terminal box cover and set aside.
6 Remove knockout from the back of the range hood and install
a UL listed or CSA approved ¹⁄
7 Place the range hood near its mounting position and run the
power supply cable through the strain relief into terminal box
(enough to make connection).
8 Tighten the strain relief screws.
A
B
C
" (1.3 cm) strain relief.
2
9

Publicidad

loading

Este manual también es adecuado para:

Pwlcl136ssPwlcl148ss