cable matters 202010 Manual Del Usuario página 7

3.2 Remote Installation
Remove the insulating tab from the end of the battery and
check that the battery is installed correctly
Troubleshooting tips:
• Replace the battery
• Make sure the Switch is turned on and remote control is
not turned off on the Switch
• The included remote control is already paired to the switch by default.
To manually pair a replacement remote control, power on ONLY the
switch to pair and hold down the Pair button on the remote control for 3
seconds until the remote control LED stops flashing. If multiple switch-
es are used in the same room, power off all other switches before
pairing.
3.3 Connection Instructions
1) Power off all source equipment
2) Make sure the switch is "OFF" before connecting any device
3) Optional: Connect the
USB-C charging cable
to a wall charger
4) Connect the switch box
to up to 2 USB-
equipped computers
with the provided Mini-B
to USB-A Cables
5) Connect the switch box
to up to 4 USB periph-
erals through the USB-
A ports
2 Computers USB 2.0 Switch with Remote Control (2 In 4 Out)
www.cablematters.com
5