Battery Charging - Viper ROS1300 Instrucciones De Uso

INSTRUCTION FOR USE

BATTERY CHARGING

NOTE
Charge the batteries when battery level is low.
CAUTION!
Keeping the batteries charged can extend their life.
CAUTION!
When the batteries are discharged, charge them as
soon as possible, as that can shorten their life. Check
WET battery electrolyte level at least once a week.
WARNING!
WET battery charging produces highly explosive
hydrogen gas. Charge the batteries in well-ventilated
areas and away from flames. Do not smoke while
charging the batteries. Always keep the tank open
while charging the batteries.
WARNING!
Pay careful attention when charging the batteries as
there may be battery fluid leakages that is corrosive. If
it comes in contact with skin or eyes, rinse thoroughly
with water and consult a physician.
Preliminary procedures
1. Drive the machine to the designated charging area.
2. Turn the ignition key (B, Figure 18) to "O".
3. Charge the batteries according to the following procedures.
Battery charging (Machine with external charger)
4. Open the protective cover (C, Figure 18). Connect the external charger
connector to the connector (E, Figure 18) on the machine. When the
external charger is connected to the machine, all machine functions are
automatically shut down.
5. Plug the external charger into the wall socket.
6. When battery charging is completed, unplug the charger from the wall
socket, then disconnect the external charger cable from the machine.
7. Check electrolyte level after the batteries are charged (for WET battery
only).
8. Insert the ignition key (B, Figure 18) and turn it to "I". Check the battery level on multifunction display (A1, Figure 18).
Battery charging (Machine with on-board charger)
9. Open the protective cover (C, Figure 18). Connect the power cord to the on-board charger plug (D, Figure 18) on the machine,
then plug the other end of power cord into the wall socket.
10. The charging status can be checked on multifunction display (A2, Figure 18).
11. When battery charging is completed, unplug the power cord from the wall socket, then disconnect the power cord from the
machine.
12. Check electrolyte level after the batteries are charged (for WET battery only).
13. Insert the ignition key (B, Figure 18) and turn it to "I". Check the battery level on multifunction display (A1, Figure 18).
GEL
A1
C
21
ENGLISH
0000.H
A2
B
D
E
Figure 18