MSW Motor Technics MSW-SG1 Manual De Instrucciones página 16

STAPLING
1. Press the staple port (7) to the place where the staple is to be driven.
2. Set the stapling power with the knob for the staples and material in use.
3. Press down the handle (2) firmly.
CAUTION! Operate the product only when applied and held stable to the stapled
surface.
REMOVING JAMMED STAPLES
The staples can jam in the staple gun. Remove the jammed staples as explained
below:
1. Gently press in the push rod (4) and pull the push rod down. Remove the whole
push rod from the staple channel (5).
2. Turn the staple gun with the staple channel (5) upward.
3. Press and slide back both ends of the release latch (6) and pull the staple
channel (5) up.
4. Remove the jammed staples from the staple channel (5).
5. Reinstall the staple channel (5) by pressing and sliding back both ends of the
release latch (6) and press the staple channel (5) back into its place until
latched securely.
REMOVING STAPLES WITH THE STAPLE PULLER
The special profile of the product provides leverage. A small up and down motion is
enough to remove the staple from the material.
Removing staples from materials:
1. Slide the bottom half of the jaw (10) under the staple to have its bar between
the jaw halves.