Publicidad
Idiomas disponibles
Idiomas disponibles
Description:
Step
Description
1
The drainage connection to the sewage system
is provided on the sedimentation tank only up to
the outlet on the trap (Item 4).
2
The outlet pipe on the trap (Item 4) can be
rotated by up to 180° depending on the
connection at the operating location.
3
To do this, slightly loosen the locking ring of the
lower part from the trap and turn the outlet pipe
to any position.
4
Re-tighten the locking ring.
5
Since the trap (Item 4) is a standard plumbing
part, there are additional connections. However,
these connections are not required, they are
sealed with blind covers at the factory.
It is recommended that you fit the rest of the
drain connection to the sewage system - after
the trap (Item 4) - using wastewater pipes
6
including a sealing sleeve.
Diameter = 45 mm
Additional adapters, pipes, hoses or fitting
7
material are available at any DIY or plumbing
store.
28 / 112 - EN -
Illustration
Publicidad
