Milwaukee 2528-20 Manual Del Operador página 5

OPERATION
To reduce the risk of injury, always
WARNING
wear personal protective equip-
ment (PPE) according to the chemical manufac-
turer's instructions. Always wear proper eye
protection marked to comply with ANSI Z87.1.
Fuel Gauge
To determine the amount of charge left in the battery,
turn the tool ON. The Fuel Gauge will light up for 2-3
seconds. When less than 10% of charge is left, 1 light
on the fuel gauge will flash 4 times.
To signal the end of charge, 1 light on the fuel gauge
will flash 8 times and the tool will not run. Charge
the battery pack.
If the battery becomes too hot, the fuel gauge lights
will flash and the tool will not run. Allow the battery
to cool down.
Adjusting the Flow Rate
Select the desired flow from Low (1) to High (3), de-
pending on the job and the chemical manufacturer's
instructions.
Setting Flow Rate
1
2
3
Trigger Lock-Off
To avoid accidental spraying, engage the trigger
lock-off.
Trigger
1. Push down the lock-off at the end of the trigger.
2. Hook the lock-off tab under the trigger.
3. To release, push the lock-off tab back into the
trigger, and unhook.
Turning the Sprayer ON/OFF
1. Before turning ON, check for any leaks around
tank, spray wand, hose, and other components
before use.
2. To turn the sprayer ON, press the power button.
3. To start the flow of liquid at the spray wand, press
the trigger. The sprayer may be operated with
trigger handle attached to carrying handle.
4. To stop the flow of liquid at the spray wand, release
the trigger.
5. To turn the sprayer OFF, press the power button
again.
NOTE: Be aware some spray material may remain
inside the spray wand and drip out. To drain, turn off
the tool, then pull the trigger and point the tool down
until dripping stops.
Pressure
0.1 GPM Low
0.2 GPM Medium
0.3 GPM High
Trigger Lock-Off
•Pull the trigger and begin sweeping the nozzle from
side to side, coating the desired surface evenly in ac-
cordance with chemical manufacturer's instructions.
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing
back onto you.
•Always empty, clean, and drain the tank after every
use as directed in the Maintenance section.
•Thoroughly clean the sprayer before storing or
before switching to a different chemical.
•When you are finished with the sprayer, thoroughly
wash your hands and any area where skin has been
exposed to the spray.
Before using any chemicals and/
WARNING
or solutions, read and follow all
original manufacturer instructions. Read all
Safety Data Sheets (SDS) and container labels
provided with the chemical. Chemicals can cause
serious bodily injury, and/or property damage.
Wear personal protective equipment (PPE) ac-
cording to the chemical manufacturer's instruc-
tions. Always wear eye protection.
MAINTENANCE
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
5
Spraying