First Power On - Memco 452 853 Guia De Instalacion

CONNECTIONS
C B
CONNECTOR
A PWR
B USB
TEL1/TEL2
C
D Antenna
SIM
E
F Switch
INSTALLATION
For a correct installation, turn the device off and read the following instructions.
1. Connect the GSM antenna to the SMA connector being careful not to over-
tighten.
2. Insert the SIM Card into the SIM holder. Be sure the SIM is inserted in the
correct way being careful of the SIM corner, with the golden contacts are
placed downwards.
3. Connect the Emergency Telephone to one of the TEL1 / TEL2 connector
present on the back side. The 2 connectors are connected together so there
is no difference between the two ports.
4. Connect the power supply and turn the GSM Gateway on using the switch.
5. For use with Memco memcom or C100 emergency telephones, the setings >
System Config > Alt. dial tone option must be ticked in the phone settings.

FIRST POWER ON

A few seconds after power on, at the end of the self test, you will see one of the following situations.
LED Regular situation
Activity NOT USED
GSM Blinking / ON 1
Status ON
D A E
DESCRIPTION
Power supply connector
USB connector for upgrades
RJ11 FXS connectors for communicators
SMA/f connector for external GSM antenna
SIM connector
Switch for the device power off-on
PIN required
NOT USED
OFF
ON
F
Emergency Telephone
Roaming/Virtual Operator
NOT USED
Flashing
ON