Cleaning the exterior
1. Turn off the water taps after finishing the day's washing. This will shut off the water supply to your
washer and prevent the unlikely possibility of damage from escaping water. Leave the lid open to allow
the inside of your washer to dry out.
2. Use a soft cloth to wipe up all detergent, bleach, or other spills as they occur. Clean the following as
recommended below:
-
Control Panel: Clean with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not
spray cleaners directly on the panel.
-
Cabinet: Clean with soap and water.
Cleaning the exterior
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial
residue that may remain in your washer as a result of washing clothes.
CAUTION
Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent
stains on your washer or laundry.
NOTE
Hard water deposits may be removed, if needed. Use a cleaner labeled "Washer safe".
Care for an extended period of non-use
Avoid leaving the washer unused for an extended time. However, if you intend to leave the washer unused
for a long period of time, follow the directions below:
1. Press POWER, and then turn the Cycle Selector to QUICK WASH.
2. Empty the tub, and then press START/PAUSE.
3. When the cycle is complete, close the water taps and disconnect the water hoses.
4. Turn off the washer, and then unplug the power cord.
5. Open the lid to let air circulate through the tub.
Untitled-1 41
English 41
2022-05-13
11:31:47