Infiniton SD-B97B Manual De Usuario página 54

MAINTENANCE
Clean the base filter
1. Open the cover.
2. Unlock three locking levers and grasp the
filter handle.
3. Remove the base filter and clean it.
If there is too much lint on the filter, clean it in
water. Dry the filter thoroughly before installing
it back.
4. Clean the rubber sealing, both at the filter and handle.
5. Re-insert the filter.
6. Lock three locking levers and make sure that the
levers are in correct lock position.
7. Close the cover until there is a click sound.
Note!
• The fluff accumulated on the filter will block the air circulation. Not cleaning the filter
regularly will increase drying time and energy consumption.
• Disconnect the power cord before cleaning!
• Do not operate the dryer without the filter!
• Clean the base filter after each fifth cycle to prevent fluff accumulation inside the dryer.
Clean the heat exchanger
！ Warning!
Do not touch the heat exchanger with your hand,
which may cause an injury.
• As necessary, approx. once every 6 months, remove the fluff from the heat
exchanger using a vacuum cleaner with a dusting brush attached.
• Clean the heat exchanger without applying any pressure. Otherwise the heat
exchanger could be damaged. The dryer will not dry
if the cooling fins are damaged or bent.
25
Filter Base