SNOWJOE 24V-X4-SB24 Manual Del Operador página 16

Fig. 29
Remove
the bolts
Fig. 30
Auger and impeller
assembly
2. Using the 12 mm open end wrench, remove the bolts that
used to secure the auger bearings, then remove the auger
bearings on both sides (Fig. 31).
Fig. 31
Remove
the bolts
Auger bearing
3. Remove 2 set of shear bolts and nuts from the auger
blades with the 12 mm end of either open end wrench.
The auger blades should be able to be removed from the
auger shaft (Figs. 32 – 33).
Remove
the bolts
Replacing Impeller
Auger bearing
Remove
the bolts
12 mm wrench end
16
Fig. 32
Shear bolts
Fig. 33
Auger shaft
Auger blade
4. Install the replacement auger blades by following the
above steps in reverse order.
1. To remove the impeller, disassemble the auger and
impeller assembly by removing the bolts from the sides of
the auger housing with the 12 mm open end wrench
(Fig. 29), and pull out the auger and impeller assembly
(Fig. 30).
2. Disassemble the worn impeller from the impeller shaft by
removing the 2 spring pins (Fig. 34).
Fig. 34
Impeller
3. Install the replacement impeller by following the above
steps in reverse order.
12 mm wrench end
Spring pins