Publicidad
Idiomas disponibles
Idiomas disponibles
Stopping the Machine
1. Release the auger trigger. Drive motor and auger will both
stop (Fig. 23).
2. Wait for all moving parts to come to a complete stop.
3. Remove the batteries.
Fig. 23
Reverse Traveling
Be careful when moving backward with the snow blower.
Always look down and behind before backing up. For safety
reasons, the machine cannot throw snow when moving
backward. When auger trigger is activated during reverse
travelling, the machine will exit the reverse mode and stop.
1. Before backing up, stop the machine by release both
triggers and wait until all movement come to a complete
stop.
2. Press the reverse button, the reverse indicator LED will
light up to indicate that the machine is in reverse mode
(Fig. 24).
3. Squeeze drive trigger against the right‑handle and the
snow blower will move backward (Fig. 24).
Fig. 24
Press the reverse button
2
Squeeze the drive trigger
Auger trigger
(Left-handle)
1
4. During backing up, pay attention not to squeeze the auger
trigger. The snow blower will stop if auger is triggered
during back up. If this happens, release both triggers and
press the reverse button again to restart backing up.
NOTE: When the reverse button is pressed, the reverse mode
is activated for 15 seconds. If the drive trigger is not squeezed
within 15 seconds, the snow blower will exit the reverse mode.
Operating Tips
m
WARNING!
Foreign objects, such as rocks, broken
glass, nails, wire, or string, can be picked up and thrown by
the snow blower, causing serious personal injury. Remove all
foreign objects from the area to be plowed before operating
the snow blower.
Snow is best removed as soon as possible after snow fall.
1. Keep the area of operation free of foreign objects that can
become thrown by the rotor blades. Perform a thorough
inspection of the area since some objects may be hidden
from view by surrounding snow. If the snow blower hits
an obstruction or picks up a foreign object during use,
stop the snow blower, remove the batteries, remove the
obstruction, and inspect the unit for damage. Repair or
replace any damaged part before restarting and operating
the unit.
2. Keep children, pets, and bystanders away from the area of
operation. Be aware that the normal noise of the machine
when turned on may make it difficult for you to hear
approaching people.
3. For larger areas, a definite pattern of operation is required
to thoroughly clean an area of snow. These patterns
will avoid throwing snow in unwanted places, a well as
eliminate the need for a second removal of snow (Fig. 25).
Pattern A: Throw the snow to the right or left side where
it is possible. For areas such as a long driveway, it is
advantageous to start in the middle. Plow from one end to
the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of
the area to be cleared, start on the opposite side.
Fig. 25
pattern A
pattern B
13
Publicidad
