Publicidad
Idiomas disponibles
Idiomas disponibles
1. Start the device by setting the ON/OFF button to position "I".
2. Adjust the rotation speed using the knob. The blades will only start to rotate
when adjusted.
3. Open the cover and throw the plants inside. Close the cover.
4. Use the brush rotation direction switch (11) to set the direction of brush
operation (upward position - clockwise rotation, downward position -
anticlockwise rotation).
5. When leaves accumulate under the brushes, open the leaf outlet with the
handle (12).
When work is complete, turn the speed control knob as far to the left as possible.
The blades will stop. Switch off the device by setting the ON/OFF button to the
"O" position and disconnect the device from the power supply.
Blade adjustment:
The three-blade cutting head has been set at the factory to do its best job.
Interference is not recommended unless it is strongly required.
1. Make sure the device is switched off and disconnected from the power supply.
2. Wear protective gloves.
3. Use the latches to open the top panel.
4. Remove the grid.
5. Loosen the axle (14) in the centre of the cutting head using an Allen key.
6. Adjust the blades by moving up and down as required
7. Tighten the blades against the axle using the Allen key.
8. Make sure the blades are not too loose.
9. Put the grid and top panel in place, securing it with the latches.
Publicidad
