Operation And Maintenance - Simu T3.5EBHZ DC Manual De Instrucciones

CANCELLING PROGRAMMING
9
During the operations in this section (§9), do not work on several motors at the same time.
9.1
12V - 2.2Ah
9.1 - Disconnect the solar panel from the T3.5EBHZ DC motor
9.2 - Disconnect the battery from the T3.5EBHZ DC motor for 2 seconds.
9.3 - Connect the battery to the motor for 7 seconds.
9.4 - Disconnect the battery from the motor for 2 seconds.
9.5 - Restore the power supply. If the motor is on the end limit position (up or down), the motor will run briefly in
one direction and then in the other, otherwise, the motor runs for 5 seconds in random direction.
The motor is now in the « cancelling mode".
9.6 - Then, confirm the cancelling of the concerned
motor from the individual control or from a new
transmitter:
- Press the PROG key of the transmitter more than 7
seconds. Maintain the pressure until the motor will
first run for 0,5 second in one direction and then in the
other, and a few second later, it will run again in both
direction.
i The memory of the motor is now completely deleted. You can connect the solar panel onto the motor, and
then proceed to the complete programming (§3).

OPERATION AND MAINTENANCE

10
- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the motorised product.
- Press the ▼ button on the control point to lower the motorised product.
- If the motorised product is moving, briefly press the "Stop" button, the motorised product stop automatically.
- The motorised product is then stopped, briefly press the "Stop" button, the motorised product moves to the
programmed intermediate position. (To modify or delete an intermediate position, see the section §7).
Tips and recommendations for use:
PROBLEMS
The motorised product is
not operational.
The operation of the
product is degraded.
The programming of the
motor is not possible.
If the motorised product still does not work, contact a drive and home automation professional.
9.2 9.3
2s
12V - 2.2Ah
POSSIBLE CAUSES
The battery of the BHZ control point
is low.
The battery of the system is low.
External radio equipment is
interfering with the radio reception
(e.g. Hi-Fi radio headphones).
Radio performance is altered.
The battery of the system is low.
9.4
2s
7s
12V - 2.2Ah 12V - 2.2Ah
9.6
PROG > 7 s
SOLUTIONS
Check the battery and replace is as
required.
Recharge the battery.
Turn off all radio equipment nearby.
Check the antenna installation.
Recharge the battery.
9.5
>>>
12V - 2.2Ah
>>
2 s
7 s
5 s
EN 7/8