san ignacio 43819 Manual De Instrucciones página 9

qualified and certified staff.
GAS LEAK TESTING
• If you suspect a leak, close the gas supply on the re gulator. Dismantle the regulator
from the cylinder and remove the cylinder from the product outdoors. DO NOT USE the
product until it was checked by competent staff.
• Carry out gas leak testing at least once a year and each time you replace or fill the cylin-
der and imme diately after first installation of the cooker.
• Ensure the knobs are in the OFF position and check all the connections are correct.
• Open the regulator and check with a soapy solution for any leaks.
- DO NOT CHECK FOR GAS LEAKS WHEN the cooker IS HOT, BUT WAIT FOR IT TO COOL.
- DO NOT USE THE COOKER IF LEAKING.
- DO NOT USE OPEN FLAMES TO TEST FOR LEAKS. DO NOT USE ANY ELECTRICAL MATE-
RIAL NEARBY WHEN YOU SUSPECT A GAS LEAK.
• When you suspect a gas leak, immediately close the tap on the cylinder.
• Formation of bubbles is an indi cation of a leak. If found, close the cylinder valve, di-
sconnect the gas cylinder regulator and remove the gas cylinder in a cool place, outdoors
and well-ven tilated. For assistance, contact the retailer or the gas suppller.
HOW TO CHANGE THE CYLINDER
• Close the gas supply on the regulator and enable the product to completely cool before
removing and re placing the cylinder. DO NOT replace the cylinder while the product is
working.
• The cylinder should be replaced in a flame-free en vironment.
• Do not smoke when replacing the gas.
• If you are replacing an empty cylinder, close the gas supply on the regulator and remo-
ve the cylinder from the product. Remove the regulator from the cylinder.
ATTENTION: The plastic parts of the product are not covered by warranty.
ATTENTION: If necessary, bring or send the appliance to the authorised support centre,
remember to clean all its parts carefully.