Cleaning The Pump - RIDGID R4093 Manual Del Operador

MAINTENANCE

CLEANING THE PUMP

 Unplug pump before handling or cleaning the pump.
 Remove the front cover.
 Using a small brush and/or water, clean any debris or
trash that is trapped on the inside of the pump.
NOTE: To maintain efficiency and extend the life of the
pump, check intake screen before use to make sure it is
clean.
 Rinse filter with clean water
If the pump will not run, try the following solutions:
 Ensure that the intake screen is free of obstructions.
 Make sure that the water hose isn't clogged or knotted.
 Be sure the unit is plugged into a functioning power outlet
and the pump is plugged into the electrical plug.
 Be sure there is adequate water in the water tank and
that the pump switch is in position II.
NOTE: Do not handle the pump while it is connected to a
power source.
STORING THE SAW
See Figure 61.
 Unplug the saw and water pump.
 Remove water tray extensions and sliding table extension.
 Close the WSUV stand.
 Secure sliding table extension to side water tray extension
using elastic strap.
 Fit the side water tray extension between center brace
and water tray. The front of the side water tray extension
should be facing the water tray as shown.
 Place the rear water tray extension onto the WSUV stand
and secure with elastic straps.
WATER TRAY
EXTENSION
(SIDE)
WATER
TRAY
STRAP
36 — English
SLIDING TABLE
EXTENSION
WATER TRAY
EXTENSION
(SIDE)
CENTER
BRACE
WATER TRAY
EXTENSION
(REAR)
STRAP
Fig. 61