Cleaning; Exterior Cleaning; Storage; Disposal And Recycling - Scheppach AB1500X Traducción Del Manual De Instrucciones Original

• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• All moving parts must be re-lubricated periodically!
Lubrication (fig. 4, 5)
This tool does not need to be greased every hour or
every day as it has a grease-lubricated lubricant sys-
tem. For a longer service life of the tool, however, the
lubricant should be changed after 40-50 hours.
1. Operate the tool for a few minutes to warm it up.
2. Turn off the tool and pull out the mains plug.
3. Open the lid (3) with the supplied maintenance tool
(C).
4. Wipe the old grease off the inside and replace
it with new grease (20-30 g) (not included in the
scope of delivery). (fig. 5)
5. Afterwards, close the lid again.
Carbon brushes
• If excessive sparks are generated, have an
electrician check the carbon brushes. Attention!
The carbon brushes must only be replaced by an
electrician.
Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-related
wear, or that the following parts are required as
consumables.
Wearing parts*:Carbon brushes, chisel
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
Ordering spare parts
Please provide the following information when ordering
replacement parts (via the service-hotline):
• Device type
• Device article number (see packaging or instruction
manual)

12. Cleaning

12.1 Cleaning
Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. We
recommend cleaning the device directly after every
use.

12.1.1 Exterior cleaning

• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.

13. Storage

Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the power tool in its original packaging.
Cover the electric tool to protect it from dust or
moisture.
Store the operating manual with the power tool.

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made
of different materials, such as metals and
plastics. Take defective components to special waste
disposal sites. Check with your specialist dealer or
municipal administration!
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised
collection point for the recycling of old electrical and
electronic devices.
www.scheppach.com GB | 23