Troubleshooting - Shine KITCHEN SJX-1WH Manual De Funcionamiento

9. TROUBLESHOOTING

PROBLEM
The juicer won't turn on.
The juicer stopped
running suddenly.
The juice yield is low or
juice flows out of the
AUGER HOUSING.
Mineral deposits have
formed on the parts.
The containers and parts
are stained after use.
POSSIBLE CAUSE / SOLUTION
• Your electrical outlet is not working. Make sure the power cord
is plugged into a functioning outlet.
• The parts have not been assembled correctly. Make sure all
parts are properly assembled as shown on page 8.
• The safety switch has not been engaged. The arrow
JUICING ASSEMBLY needs to align with the lock symbol
the MAIN BODY to engage the safety switch.
• Use the REVERSE Function
machine still isn't running, try cleaning the machine thoroughly
before use.
• If the motor overheats during juicing, your machine will
automatically shut off for protection. If this happens, it is
recommended to allow your juicer to rest for 20-30 minutes
after overheat protection kicks in.
The AUGER HOUSING and PRESSURE PLUG are not installed
properly. Make sure the PRESSURE PLUG is plugged all the way
into its slot and the AUGER HOUSING is fully seated on the MAIN
BODY. Refer to instructions on page 8.
Mineral deposits are common over time and can cause parts to
look dull. To remove mineral deposits, we recommend soaking in
a solution of hydrogen peroxide and water (50/50) for 30 minutes
to an hour, then scrubbing with warm soapy water. To prevent
buildup, wash the parts right after juicing for best results. Do not
let them sit.
Parts can get stained due to the natural dye pigments of fruits
and veggies, such as turmeric, carrots, and beets. Make sure to
clean the juicer immediately after use under running water using
the cleaning BRUSHES. You can try to remove some of the colored
stains by soaking the parts in 70% white wine vinegar and 30%
water.
on the
to dislodge any jams. If the
EN
on
15