Yuasa YCX1.5 Guia Del Usuario página 8

No charging
current.
No charging
current.
Full / float light
won't come
on or full LED
flashing.
Maintenance
The charger is maintenance free. If the power cord is damaged, the charger must
not be used. The case should be cleaned occasionally. The charger should be
disconnected from the power while cleaning.
8
LED fault
indicator is ON
and charging
percentage LED
bar flashing
or blinking in
sequence.
LED fault
indicator is fast
flashing.
LED fault
indicator is
flashing. The
charging
percentage LED
bar is flashing
or ON.
Battery is
severely
sulphated.
Battery has a
damaged cell.
Overheat
protection mode.
Battery capacity
too large for the
battery charge
setting and it
has timed out or
battery is slightly
sulphated.
Check the battery
condition, age etc.
Battery may need
replacement.
Check the battery
capacity.
Move battery and
charger to cooler
environment.
Check the battery
charger.
Check the charger
specification
matches the battery
capacity.
Battery cannot be
charged and must
be replaced.
The charger's
charge rate might
be too low. Check it
is sufficient for your
battery.