Yuasa YCXLI2 Guia Del Usuario página 4

charger to the positive (+) battery terminal and then connect the black lead
from the charger to the vehicle's chassis and far away from the fuel line.
(Only if access to negative terminal is not possible).
If positively earthed - First connect the black lead from the charger to the
negative (-) battery terminal and then connect the red lead from the charger
to the vehicle's chassis and far away from the fuel line. (Only if access to
positive terminal is not possible).
Once connected to the battery, connect the charger to mains power.
The charger will automatically start when mains power is connected and
switched on.
(Note: If the LED fault indicator illuminates red, please check your
connections as it's likely that the positive and negative leads are reversed.
Refer to Troubleshooting for further information).
Disconnecting the battery charger from the battery
If the battery is out of the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait
for a minimum of five minutes before disconnecting the charging leads.
Remove the black lead followed by the red lead.
Check electrolyte levels if possible. (They may need topping up with
distilled water after charging).
If the battery is in the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait
for a minimum of five minutes before disconnecting the charging leads.
Remove the black lead from the battery or vehicle chassis.
Remove the lead from the vehicle chassis.
Remove the lead from the battery.
Check electrolyte levels if possible. (They may need topping up with
distilled water after charging).
Dual clamp to eyelet conversion
The charger is supplied with clamps that feature integrated eyelets. To
convert the clamp into an eyelet, simply remove the retaining screw and
washer. To reattach the clamps, follow this process in reverse (image 1).
1
The eyelets can be used for permanent connection to a battery whilst it
is fitted in a vehicle. They should be securely tucked out of the way and
connected to the charger when using the connection plug when charging is
required (image 2).
Selecting the correct MODE for your battery type
4
2
Press the MODE button to select the correct
charging mode for your battery type. The charger
will automatically remember the previous setting.
When Li mode is selected, the charger will
automatically detect that it is connected to a
lithium-ion or LifePO4 battery.
If the battery's BMS protection has been triggered
due to low Voltage, the charger will automatically
compensate for this to enable the battery to be
charged.