Better Homes and Gardens BHW-10008 Manual De Instrucciones página 4

C
③ x 8
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Place the Seat (B) upside down on a level and protected surface.
3. Remove the plastic caps from the hanger bolts of Chair Front Legs (C). Attach two Front Legs (C) to the
front corner blocks of the Seat Frame (B) by inserting the pre-attached hanger bolts through the drilled
holes on corner blocks, and fit the Flat Washer (5), Lock Washer (4) and Hex Nut (3) onto each hanger
bolt. Tighten the hex nuts with the provided open wrench.
NOTE: DO NOT fully tighten all the nuts until the chair has been adjusted and all the legs are levelled
so that they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains
level.
Assembly Instructions
C
B
④ x 8
DO NOT fully-tighten the nuts or bolts initially until all the nuts or bolts are
C
⑤ x 8
4
C
5
4
3