Publicidad
Idiomas disponibles
Idiomas disponibles
battery is fully charged as soon as the battery charge indicator (5) is all lit after the button
(8) is pressed.
• During the charging procedure, the handle of the machine warms up. This is normal.
• When the charging is finished, disconnect the battery charger from the socket.
• Do not use the machine during the charging procedure.
BATTERY POWER STATUS DISPLAY
• You can see it pressing the operating switch (8).
• The charge status is displayed by three multi-coloured LED´s (5):
- Red LED is on <20%
- Red + yellow LED's are on 20%-70%
- All three LED's are on >70%
• Once only the red LED is lit, the screwdriver must be re-charged.
INSERTING AND EXTRACTING TOOL BITS
• IMPORTANT! Always turn off the switch before you change the screw bit to avoid
an unintentional starting of the machine. When the machine is completely stopped,
insert or extract the screw bit.
• Only use tool bits which can be securely fastened in the chuck and for which the bits
has been designed.
• Before using the machine check whether the screw-bit is inserted correctly. Avoid
over-tightening screws, otherwise the screw head may be damaged or stripping of
the threads may occur.
ON/OFF TRIGGER
• Use the On/Off trigger to start the machine and keep holding it for continuous op-
eration.
• The rotation speed can be varied by depressing the On/Off trigger. The more the
trigger is depressed, the faster the rotation speed is.
• To switch the machine off, release the On/Off trigger
LED WORKING SPOT LIGHT
• Forward pushing the switch (4) will turn on the LED working spot light (7).
• Backward pulling the switch (4) will switch off the LED working spot light (7).
Publicidad
