Publicidad
GENERAL SAFETY REQUIREMENTS
This instruction manual is intended solely for use by qualified professionals.
The installation, electrical connections and adjustments must be made in accordance with the current legislation in each country.
Carefully read the instructions before starting to install the equipment. Incorrect installation can be dangerous.
Packing material (Plastic, expanded polystyrene, etc.) should be disposed of without causing environmental damage and should be kept out of
the reach of children, as it is potentially dangerous.
Do not install electrical equipment in an explosive environment or atmosphere. The presence of gas or inflammable fumes represents a severe
security risk.
Before installing the equipment, make all necessary modifications to the door/gate to ensure that there is no risk of crushing, cutting or any other
possible movement that could cause harm.
The manufacturer of the equipment is not responsible for the automated door/gate not meeting the relevant safety standards, nor for the possible
deformations that could occur during use.
Safety devices (photo-electric cells, pneumatic strips, etc.) should be installed in accordance with the current safety standards. These safety
devices should be installed such as to avoid any possible crushing, cutting or danger in general by the door/gate that is being automated. Apply
the relevant warning sings as per the current standards to indicate the potential danger areas.
Each installation should have clearly visible identification information of the automated door/gate. Install a two-pole switch at the power supply to
turn off the supply in case of emergency.
Check that there is a differential and thermal cut-out. Always earth the equipment and the door/gate.
MANUFACTURER DECLARATION
(Directive 2006/42/CE, Appendix II, part B) Manufacturer: Hidro – Domèstics, S.L.
Address: C/ Fusteria, 26, 28, 30, 08551 Tona Barcelona – SPAIN
Declares that the systems with part numbers: 3LC*D*, 3LC*RT*, 4LR*D*, 4LR*RT*
Are built to be used in a machine or to assemble with other machines to build a machine considered by the Directive 2006/42/CE, as
-
modified.
Conform to the conditions of the following CE Directives:
-
Electro-magnetic compatibility Directive 2014/30/UE, as modified. Low tension directive 2014/35/UE, as modified.
Safety standard for hydraulic transmission systems EN-ISO4413:2011.
And also declares that it is not permitted to use the machinery until such time as the machine in which it is to be used, or of which is component
part, has been declared in conformity with the conditions of the directive 2006/42/CE and any relevant national legislation.
Tona a 01/07/2021
Jordi Roquet(Director)
-4-
Publicidad
