Initial Configuration - Ledwood ROUND300 Guia Del Usuario

INSTALLING THE DUST COVER
See the diagram below to install the plastic dust cover.

INITIAL CONFIGURATION

MAINS POWER CONNECTION
Make sure that the mains voltage of your home corresponds to the operating voltage of the device. Your device is
ready to be connected to a 5V DC mains power adaptor.
CONNECTION TO AN EXTERNAL AUDIO SYSTEM
Playing a record
Before use, make sure that the safety tie (arm rest/lock) and the cartridge protector (stylus/cartridge) have been
removed and the tone-arm lock has been released.
The platter will start to turn when you move the tone arm towards the record. Gently lower the needle onto the outer
edge of the record using the tone-arm lever.
When a record reaches the end
The platter stops automatically if the automatic stop switch is in the «ON» position.
The platter will continue to turn if the switch is in the stop position.
USB STICK AND SD CARD RECORDINGS
LISTENING TO MUSIC
- If you want to listen to or pause the music on your SD card or USB stick, turn the power supply and volume control
knob clockwise; the music will start to play automatically.
- If you have installed both an SD card and a USB stick, the last installed will start to play. You can select the required
source by pressing the MODE/REC button. (SD => USB). Only mp3 file format is supported.
RECORDING MUSIC
You can convert your vinyl records into digital mp3 files on an SD/MMC card or a USB stick.
- Play your 'vinyl' music as described in Listening to music'.
5