Water Treatment - Iberspa SW11487 Manual De Uso E Instalación

· TOUCH PANEL
TEMPERATURE CONFIGURATION
PRE-SET FILTER CYCLES
Using the same adjustment as Setting the Time, Filter Cycles are set using a start
time and a duration. Each setting can be adjusted in 15-minute increments. The panel
calculates the end time and displays it automatically.
The Filter Icon
the Filter Cycles.
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2.
Press "2" again to turn Filter 2 ON or OFF. When Filter Cycle 2 is ON, it can be adjusted
in the same manner as Filter Cycle 1. It is possible to overlap Filter Cycle 1 and Filter

4.2. Water treatment

Checking the water status is one of the most important steps.
pH ADJUSTMENT
A pH index of between 7.2 and 7.6 is recommended.
The pH level measures the acidity and alkalinity: Values above 7 are alkali and below 7,
are acid.
| TOUCH PANEL
018
| TOUCH PANEL
on the Settings Screen takes you to a screen where you control
019
H = High Temperature Range.
L = Low Temperature Range.
Adjust set temperature higher.
Current water temperature.
Adjust set temperature lower.
ENG
29