Descargar Imprimir esta página

EAS ELECTRIC EFSL-RC75A Manual De Instrucciones página 35

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Pass section B of the connection cable set
through the wiring hole in the rear cover of the wired
controller, and fix the rear cover of wired controller
on the wall using four plastic studs and the Philips
head screws, as shown in the figure below.
4. Connect terminal B to the 5-core socket in the
PCB of the IDU main control board, as shown in the
figure below.
After the terminal is properly connected, put
the excess cable back to the hole on the wall
(instead of leave it in the wired controller).
CAUTION
14

Publicidad

loading