Publicidad
Idiomas disponibles
Idiomas disponibles
9.- RESET: press and hold this button for 5 seconds to reset the transmitter's IP addresses to factory
defaults.
12
10.- Power inlet for the supplied power adapter.
11.- Data transmission LED indicator.
12.-
: receiver input, RJ-45 connector.
13.- Connection status LED indicator.
14.- IR IN: input for connection of the remote control receiver.
1
2
15.- HDMI OUTPUT: digital A/V output, HDMI connector.
1
4
5
REMOTE CONTROL
7
8
0
CH+
This remote control only controls the transmitters and receivers by pointing its IR
sensor at the front of the units. Under no circumstances will it control the sources.
2
1.- 0-9: changes the transmission channel.
2.- CH+/CH-: decreases/increases the transmission channel by 1 unit.
EXTENDER MATRIX
CONNECTION AND OPERATION
EXTENDERS FOR REMOTE CONTROL OF A/V SOURCES
Supplied with the transmitters and receivers is the cable with IR emitter or receiver that allows remote
control of the source from the location of the receiver.
1.- Insert the transmitter into the IR OUT connector of the transmitter and face the IR sensor to the sensor
of the source.
2.- Insert the receiver into the IR IN connector of the receiver in a visible place in order to receive the signal
from the remote control.
DIRECT CONNECTION WITH CAT 5e/6 CABLE (1 Transmitter - 1 Receiver)
- Connect the digital A/V source to the HDMI INPUT of the transmitter via HDMI cable.
- Connect the HDMI OUTPUT of the receiver to the TV via HDMI cable.
- Use Cat 5e/6 cable up to 120 meters to connect the transmitter and receiver with IEEE-568B standard
connection at the input
- Power the transmitter and receiver with the supplied power adapters.
- Turn on the digital A/V source and the TV.
- Finally, select the transmitter's TX CHANNEL on the receiver. TX CHANNEL on the transmitter and receiver
must match in order to receive the A/V signal.
10 11 12 13
3
6
9
CH-
.
1
14
15
7
8
9 10
11
IR OUT
- 3 -
2 3
4
5
6
12
HDMI INPUT
1
2
EN
1
2
3
4
5
6
7
8
9
0
CH+
CH-
EXTENDER MATRIX
Publicidad
