Removing The Blade; Operation - Power Stroke PSL18CS Manual Del Operador

NOTICE:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
NOTE: Do not run the circular saw with spindle lock engaged.
 Wipe a drop of oil onto the inner blade washer and outer
blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before
placing blade on spindle. Failure to do so could cause an
accident since blade will not tighten properly.
 Fit the saw blade inside the lower blade guard and onto
the spindle.
NOTE: The saw teeth point upward at the front of the
saw.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
ASSEMBLY
 Replace the outer blade washer.
 Depress the spindle lock, then replace the blade
screw. Tighten the blade screw securely by turning it
counterclockwise.
 Return the blade wrench to the storage area.
NOTE: Never use a blade that is too thick to allow the outer
blade washer to engage with the flats on the spindle.

REMOVING THE BLADE

See Figure 2, page 12.
 Remove the battery pack from the saw.
 Remove the blade wrench from the storage area.
 Position the saw as shown, depress the spindle lock, and
remove the blade screw by turning it clockwise.
 Remove the outer blade washer.
 Remove the blade.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
paneling)
 Cross Cutting/Rip Cutting
 Bevel Cutting
 Pocket Cutting
WARNING:
Never use abrasive cut-off wheels of any kind with
this saw. Use of non wood cutting blades can result in
property damage or serious personal injury.
WARNING:
Battery tools are always in operating condition. Lock
the switch when not in use or carrying at your side,
when installing or removing the battery pack, and when
installing or removing blades.
Page 7 — English