König KN-LM30 Manual De Uso página 2

Upper cover
Lower cover
Entrance
Forward/Backward
1. Connect the power plug to the power socket. Be sure the voltage is 220V.
2. Push the start/stop button into the starting position. The power LED, on front of
the machine, blinks red.
3. Wait until the heat LED, on the front of the machine stops blinking and become
constantly green.
4. After 6 minutes the machine is ready for use. During operation the green LED will
blink. Wait till the machine is heat up again and the LED blinks green again.
5. Check the schedule for the temperature which is needed for the sort thickness
of the film you are using. Film is 100 mic. Slide the temperature switch into the
recommended position.
6. Put the laminating film in the machine. The film will run automatically through the
machine.
7. With the button forward/backward you can run the film during operation forward
or backward.
8. For cold laminating push the button into the cold position and slide the temperature
switch to the cold position.
WARNING:
Be careful, during operation the machine will become hot. Don't touch the top of the
machine. Use only special laminate film.
Specifications:
Voltage: 220V~240V, 50Hz
Power: max. 450W
Ventilating window
Exit
Heat/Cold
Start/Stop
Plug
1
Heat LED (GREEN)
Temperature controller
Power LED (RED)