EGAmaster ROSCAMATIC 50-2 Manual De Instrucciones página 10

C) PREPARATION FOR THREADING
C1- Select the correct die head and dies as required.
C2- Insert the die thread lining it up with the positioning ball of the die head, until a "klick" sounds.
C3- Once the dies are positioned, turn the lever nut to lock until you get the desired measure.
C1
D) THREADING
D1- Raise cutter and reamer out of the way.
D2- Lower the die head to the carriage in its fixed position.
D3- Switch on the machine checking that the oil is flowing correctly from the die head, if not, you
can regulate it by the oil flow adjustment knob on the right bottom part of the carriage.
D4- Advance the carriage until the dies engage the pipe pressing it to start the threading and kee-
ping it until 3 threads are produced, releasing after because the thread itself would drive the
carriage during the rest of the threading. When the dies be alocated just at the end of the pipe,
turn up die head hand gear.to allow the dies could retire.
D5- Stop the machine.
D6- Retract carriage to the initial position.
D1
D4
10
C2
D2
D5
C3
D3
D6