6. Place the upper door on a smooth
surface with its panel upwards. Loose
screw @ and part CD, then lnstall
them to the left side and tighten securely.
O
CD Stop block
®
-==�
f:
7. Unscrew the two special flange self
tapping screws which are used for fixing
the middle hinge part, then remove the
middle hinge part that hold the lower door
in place.
NOTE: When removing the door, watch
for washer(s) between the lower hinge
and the bottom of the lower door that
may stick to the door. Do not lose.
t
Self-tapping screw
t
8. Place the lower door on a smooth
a
surface with its panel upwards. Loose
screw @ and part CD, then lnstall
them to the left side and tighten securely.
(i)Stopblock
® Self-tapping screw
___, " -- CD
1
--@
9. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
1 O. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts, and
the lower hinge part by unscrewing
the special flange self-tapping screws.
@--\9
CD Lower hinge part (right)
® Adjustable bottom feet part
®
Self-tapping screws
15