Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5:
To set flexion at 30°, 60° or 90° remove screw using Allen
wrench (included), pull lock to highest position ④A and
rotate hinge cap to reveal flexion stops ④B. Place the screw
through the washer and insert at desired setting ④C. Use
Allen wrench to tighten. Repeat on opposite side.
Step 6:
To change locking position from 0° to 5°, use the Allen
wrench to remove both screws ④D. Slide thigh shell
backwards until both holes align at the 5 setting ④E. Insert
screw and tighten. Repeat on opposite side.
Step 7:
To disengage drop locks pull up on the lock until it clicks
into the unlocked position ④F. Hinge will move freely
between extension and flexion settings ④G. To engage the
hinges, press buttons at the front of lock ④H and straighten
leg completely. Hinges will lock into place. ④I
Warning:
The adjustment of the flexion/extension must be decided
and performed by the healthcare professional, not by the
patient. Both hinges MUST be adjusted to the same angle.
There can be damage to the hinges, and compromises
(including injury) to the patient, if the settings are not the
same on both hinges.
Patient Instruction Guide:
The medical professional who performed the initial
fitting of your brace should have made all the necessary
modifications to the corrective force applied by the knee
brace, selected the appropriate hinge pads, and adjusted
the length of the straps. The fitter should have also
explained how to put on your brace. While the process
is relatively simple, you are encouraged to refer to the
instructions below to ensure you are putting the brace on
correctly.
Fitting instructions:
Step 1: Sit on the edge of a chair and slightly bend your leg
(30° to 60°).
Step 2: Place the knee brace on your leg so that the oval
shaped pads attached to the inside of the hinges press
against both sides of the knee. The middle of the pads
should line up between the middle and the upper third of
your knee cap and should also be centred on the side of
your leg ❷.
Step 3: The suspension strap ❶ A should be position above
the natural contour of the upper calf. This strap should be
tightened in the flexion fold behind the knee. It is the most
important strap for preventing the brace from slipping
down your leg. By tightening the suspension strap A above
the calf muscle in the flexion fold behind the knee you will
ensure that the hinges are at the correct level on the leg.
Step 4: Next fasten and tighten the lower strap C, then the
two straps behind the thigh D and E. It should not normally
be necessary to readjust the front straps B and F.
Carefully follow your physician's instructions regarding
physical activities and the specific use of this product. It
may take several weeks to feel comfortable with the brace
on your leg.
Adjusting the correction:
During your initial fitting, the healthcare professional
should have made any necessary adjustments to obtain
a base level of corrective force. If you feel the need for
additional correction in the future, or if you are feeling
any discomfort, or are experiencing any other issue with
the fit, function or suspension of the brace, stop wearing
your brace until you can see your physician or the medical
professional who fitthe brace. The manufacturer cannot be
held responsible for problems or injuries resulting from any
unsupervised adjustments.
Precautions:
• Follow
the
recommendations
professional who prescribed or supplied the product. In
case of discomfort or hindrance, or any unusual reaction
during the use of the product, remove the knee brace and
consult this healthcare professional.
• Restrict yourself to physical activities authorised by the
doctor who is responsible for evaluation your physical
condition prior to defining the activities that are safe and
appropriate for you to do while wearing the brace.
• The use of rigid orthotics is not recommended during
sports or other activities giving rise to shocks.
• Store the brace at normal room temperature, and don't
expose the brace to extreme temperatures, especially
very hot temperature. To protect the paint finish, when
not in use, keep the brace in the original packaging or
a small bag. For reasons of hygiene, performance and
safety, this brace should only be used by the original
users, and should not be worn by any other person.
Care and warranty:
Care of the knee brace
• Hinges: The hinges on the brace are pre-lubricated in the
factory. If sand, dirt or water gets inside the hinges, they
may require lubricating again. If you notice the hinges not
gliding smoothly, a few drops of a synthetic lubricant can
be applied. Wipe off any excess lubricant before wearing
the brace to prevent stains on clothing.
• Straps: After prolonged use, if the fibres on your strap do
not adhere as well to the Velcro tab, cut the strap shorter
so the Velcro tab adheres to a section of the strap that has
fresher fibres. If this is not possible, you should contact
the medical provider who fit your brace.
• Pads: The brace is lined with padding that provides a
comfortable interface between the leg and the shells. The
straps also have pads. Do not remove these pads from the
brace or straps. Wipe the pads after each use to remove
any moisture and let the pads air dry. You can also clean
the pads with a mild anti-bacterial soap and rinse them off
with fresh water. Do not wash the pads in a machine and
do not dry in a tumble dryer.
Washing instructions:
• Do not use detergents, fabric softeners or aggressive
products (products containing chlorine).
• Squeeze out excess water.
• Dry away from heat sources.
Composition:
Aluminum, stainless steel, nylon, polyurethane, vinyl
Disposal:
Dispose of in accordance with local regulations.
Parts and after sales service:
Comfort pads, condylar pads, hinge caps, straps and other
parts of the knee brace may need to be repaired or replaced
due to normal wear or damage. If this is the case, you should
contact the professional who assisted you in ordering and
fitting your brace. Certain parts are covered by a limited
warranty (see information below).
Warranty:
Under normal use and conditions, the shells and hinges of
the brace are covered by a one year warranty against defects
or breaking. Straps, hinge caps, and other replaceable parts
are covered for six months. If you experience a problem
with the fit or function of the brace, please call the medical
provider who fit your brace.
Product disclaimer:
This knee brace is a product prescribed by a physician and
should be used in accordance with his or her instructions,
as part of a treatment plan for global health. Due to
variations in age, health and physical condition, Thuasne
does not make any specific recommendations regarding
appropriate activities for the user of this knee brace. As
the manufacturer has no role in patient selection, or fitting
and adjusting the knee brace, or any role in instructing
the patient and/or monitoring the use of the knee brace,
Thuasne cannot be held responsible for the results arising
from the use of the knee brace.
of
the
healthcare
Keep this instruction leaflet.
Publicidad
