Storage And Transportation - DeWalt DXDP610100 Manual De Instrucciones

English
WARNING:
The user must weigh the tool to be
tethered to ensure they do not exceed the maximum
safe working capacity of the tool lanyard or any
part of the tethering system. User should also refer
to the label or user manual for information on
maximum capacity.
WARNING:
After every use or if the tool
lanyardhas arrested a tool fall, the tool lanyard
should be checked by a competent person. If
deemed not fit for use, it should be immediately
removed from use.
WARNING:
Do not attempt to disassemble the
unit or make repairs to the equipment. Send the
equipment back to the manufacturer, or person or
entities authorized in writing by the manufacturer
to make repairs to the equipment.

STORAGE AND TRANSPORTATION

a ) When not in use, store equipment where it will not be
affected by heat, light, excessive moisture, chemicals,
or other corrosive elements.
b ) The product should be kept and transported in its
original packaging or in airtight packaging.
DISPOSAL
a ) If any wear or damage is observed, the product
must be removed from service and destroyed. Using
scissors, cut the textile to dismantle it.
12
WARNING:
Whatever combination you use,make
sure that it does not interfere with the safe use of
the tool.
LIFESPAN: The estimated product Lifespan depends if the
product passes the pre use inspection and periodic inspection
by competent person. The following factors can reduce the
Lifespan of the product: intense use, contact with chemical
substances, especially aggressive environments, extreme
temperature exposure, UV exposure, abrasions, cuts, violent
impacts, bad use or maintenance.
DISCLAIMER: Prior to use the end user must read and
understand the manufacturer' s instructions supplied with
this product at the time of shipment and seek training from
their employer' s trained personnel on the proper usage of the
product. Manufacturer is not liable or responsible for any loss,
damage or injury caused or incurred by any person on grounds
of improper usage or installation of this product.
PRODUCT LABEL
Product label has the following information:
a ) Manufacturer's logo g ) Serial number
b ) Product category h ) Batch number
c ) Product name i ) Date of manufacture
d ) Model number j ) Load capacity
e ) Material of construction k ) Relaxed length
f ) Relevant standards l ) Max. expanded length
EQUIPMENT RECORD
Product
Trade Name
Model & Type/ Identification
Manufacturer Address
Year of Manufacture Purchase Date
Other relevant information (e.g. document number)
PERIODIC EXAMINATION AND REPAIR HISTORY
Date
Reason for entry
Defects noted,repairs
(periodic examination
carried out and other
or repair)
relevant information
© 2021 D WALT. D WALT® is a registered trademark of the D
E E
All rights reserved. The yellow and black color scheme is a trademark for D
Accessories.
Trademark Licensee: DFP Safety Corp. 20711 Holt Av. # 1525 Lakeville, MN 55044, 800-391-1862,
www.dfpsafety.com.
A licensee of D WALT Industrial Tool Co.
E
English
Identification number
Tel, fax, email into use
Date first put into use
Name and signature Periodic examination
of competent person next due date
WALT Industrial Tool Co., used under license.
E
WALT Power Tools and
E
13