Publicidad
Idiomas disponibles
Idiomas disponibles
2. IMPORTANT
Before installing VAPORINO INOX MAXI, it is necessary to set up a protected electrical
socket suitable to VAPORINO INOX MAXI power (it is better to use an earth protector
magneto-thermic switch 16 A ld 30 mA). For the transport and the movement of
VAPORINO INOX MAXI, take the generator only by the specific handle. Never pull its
electric wires (fig. 1).
This steam generator is not suitable for people (children included) with physical or mental
handicaps or inexperienced persons, unless they are instructed by a person who takes the
responsibility for their safety. Children must not play with the steam generator.
3. OPENING OF PACKAGE
1. Open the box containing VAPORINO INOX MAXI, take the instructions manual and
read it carefully.
2. Remove VAPORINO INOX MAXI from the box, assemble the cable support and
insert it deep into the special support holder placed on the back side of VAPORINO
INOX MAXI (fig. 1).
3. Fix the cable and the tube of the iron to the support hook, avoiding entwining.
4. Place the iron on the rubber iron rest supplied with the machine (fig. 1).
5. For VAPORINO INOX MAXI supplied with trolley: screw the trolley knob on the
proper connection under the base of the VAPORINO INOX MAXI (fig. 2).
4. CONNECTION AND STARTING
With VAPORINO INOX MAXI switched off and disconnected plug:
1. Unscrew the security valve plug of VAPORINO INOX MAXI (fig. 1) and fill the boiler
with water to the desired level (fig. 2) paying attention not to overfill it. It is advisable
to use a funnel. Take the plug by the plastic part and screw it again: do not tighten
too much or its gasket might get spoilt (see section 7).
2. Insert the plug into a 230 V 16 A socket.
3. Switch on the boiler (fig. 2 B) and the iron switch (fig. 2 A) and adjust the thermostat
of the iron (fig. 3) on "cotton".
4. Wait for the boiler lamp to switch off (fig. 2 C): the manometer should mark about
2,5/3 bar. At this point seize the iron by cork handle and press the micro-switch of the
iron (fig. 4) for 4 or 5 times, so that steam comes out. It is important to make sure
that the steam is saturated (by pressing the micro-switch with the iron pointed
towards the floor). It is also possible to adjust steam flux by turning the regulation
knob (fig. 2). Now everything is ready for ironing. During ironing operation, the
boiler lamp switches on and off signalling that the machine is working properly (fig.
2 C).
Vaporino Inox Maxi mod. 2016
10
2016
Publicidad
