Descargar Imprimir esta página

Using The Rechargeable Battery - HumanTechnik earis XS Instrucciones De Servicio

Ocultar thumbs Ver también para earis XS:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 90

Using the rechargeable battery

Insert the supplied battery into the receiver, until it clicks into place (the
battery only fits one way)
Charge the receiver completely and without interruption before first use. A
complete charge will take about 2 hours.
The battery status on the receiver lights up red when the battery level is low.
When system is in use and the battery in the receiver is low, the status LED
on the receiver flashes RED constantly, and you will hear a beep every 30
seconds. After a few minutes, the receiver will automatically switch off.
To charge the battery, place the receiver in the charging dock of the Trans-
mitter. The LED bar must point upwards, magnets keep the receiver in the
correct charging position.
The charging status LED on the front of the receiver will illuminate red, the
charging status LED will switch to green when the battery is fully charged.
We recommend that you always place the receiver in the charging dock of
the transmitter when the system is not in use, this will always keep the bat-
tery in optimum condition. The intelligent charging circuit within the system
will prevent overcharging of the battery.
34 English
Earis_XS_PR_BA_DE_EN_F_NL_E_I_pocket2200808.indd 34
Earis_XS_PR_BA_DE_EN_F_NL_E_I_pocket2200808.indd 34
10.08.2022 08:22:55
10.08.2022 08:22:55

Publicidad

Solución de problemas

loading