Isoplam PLAM MIX 120 Manual De Uso & Mantenimiento página 15

Before a long work pause or at the end of the shift, the mixer tank must
be thoroughly cleaned by abundant washing. If you use a high-pressure
hose to clean the machine, do not aim the water jet directly at the plug/
socket connection or power switch.
Do not strike the tank with hammers, shovels, etc. Dents reduce the
rect, applying a force of around F=1.5 kg at the centre of the belt's free
6. Once the belt is correctly tensioned, tighten down the 4 bolts (ref.3,
pulley.
sion is correct, applying a force of around F=1,5 kg at the centre of the
6. Once the belt is correctly tensioned, tighten down the 4 bolts (ref.3,
new belts, and repeat the check every 18-20 hours.
dual safety equipment. The machine is equipped with notices to indicate
the residual risks and how to avoid them.
-
-
-
MOUNTING THE WHEELS ON THE LEGS
EXTRACT THE TWO REAR LEGS, AND INSERT A WHEEL ONTO
THE PIN ON EACH ONE. THEN SECURE THE WHEEL BY
INSERTING THE OUTER COTTER PINS INTO THE
THROUGH HOLES (FIG.5).
15
UPPER AXLE
INSERT THE COTTER PINS INTO
THE TWO THROUGH HOLES IN
THE AXLE (FIG. 1)
FIT THE WHEELS ONTO THE AXLE
(FIG. 2)
INSERT THE SPACER
BETWEEN THE TWO
BRACKETS ON THE FRAME,
AND THEN INSERT THE
HEXAGON HEAD SCREWS
INTO THE HOLES (FIG.3).
TAKE THE AXLE WITH THE
WHEELS AND SCREW IT IN
PLACE USING THE HXAGON
HEAD SCREWS INSERTED
PREVIOULSY (FIG. 4).
GB