Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLOGY
Volts
Direct Current
Alternating Current
Amps
Hertz
Lock
Power button
WARNING
Universal Serial Bus (USB)
Universal Serial Bus Type-C
(USB-C)
Do not allow battery to contact
corrosive or conductive fluid.
Do not step
Overload Indicator
Overtemperature Indicator
BND
Bonding Terminal
BFP
Backfeed Protected
Class II equipment with functional
grounding
UL Listing for Canada and U.S.
US
C
Risk of Electric
Shock
5
INSTALLATION
EXTENSION CORDS
Grounded tools require a three wire extension
cord. Double insulated tools can use either a two
or three wire extension cord. As the distance from
the supply outlet increases, you must use a heavier
gauge extension cord. Using extension cords with
inadequately sized wire causes a serious drop in
voltage, resulting in loss of power and possible tool
damage. Refer to the table shown to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater
the capacity of the cord. For example, a 14 gauge
cord can carry a higher current than a 16 gauge cord.
When using more than one extension cord to make
up the total length, be sure each cord contains at
least the minimum wire size required. If you are using
one extension cord for more than one tool, add the
nameplate amperes and use the sum to determine
the required minimum wire size.
Guidelines for Using Extension Cords
•Do not exceed the load rating of the extension
cord. Be mindful of the individual and accumula-
tive electrical load for all attachments. Exceeding
the load capacity of the extension cord could result
in overheating, fire, electrical shock, or injury.
• If you are using an extension cord outdoors, be sure
it is marked with the suffix "W" to indicate that it is
acceptable for outdoor use.
• Be sure your extension cord is properly wired and in
good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified
person before using it.
• Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
Recommended Minimum Wire Gauge
For Extension Cords*
Nameplate
Amps
25'
0 - 2.0
18
2.1 - 3.4
18
3.5 - 5.0
18
5.1 - 7.0
18
7.1 - 12.0
16
12.1 - 16.0
14
16.1 - 20.0
12
* Based on limiting the line voltage drop to five volts at 150%
of the rated amperes.
Extension Cord Length
50'
75'
100'
18
18
18
18
18
16
18
16
14
16
14
12
14
12
10
12
10
--
10
--
--
150'
16
14
12
12
--
--
--
Publicidad
