Robern CRAFT Serie Instrucciones De Instalación página 3

Ocultar thumbs Ver también para CRAFT Serie:

INSTALLING THE MIRROR

1. Unpack all parts and place them on a protected work surface. Refer to the mounting bar requirements (below) making sure that all

requirements are met when installing the mounting bar.

•

At least one screw MUST be installed in a structural member (stud, etc.)

•

All mounting screws must be used in mounting bar.

2. Determine the exact location of the fixture and mark holes on the wall surface using the holes as a guide. Make sure that the

mounting bar is level when securing it to the wall.

3. Drill pilot holes in each mounting location on the wall. When necessary, the holes should be large enough to accommodate wall

anchors [203-1552].

NOTE: Wall anchors appropriate to the wall type must be inserted in any location where a structural member isn't available.

4. Where needed, insert wall anchors into the holes in the wall.

5. Use the mounting screws [203-1554] to secure the mounting bar to the wall. Tighten until there is strong resistance. DO NOT

OVERTIGHTEN.

NOTE: At least one screw MUST be installed in a structural member (stud, etc.)

800.877.2376

www.robern.com

9/32"

(7 mm)

[203-1554]

[203-1552]

Part no. CB-209-1404 07/20/2021

Craft Series Mirror

Tabla de Contenido