BGS technic 3521 Instrucciones De Uso página 2

INTENDED USE
This wishbone lever is used for comfortable, safe pressing down and holding the wishbone when
replacing the wheel bearing, disassembly of the drive shaft, renewing the shock absorber, etc.
SAFETY ADVICE
•
Check the tool for damage before use, do not use the tool if it is damaged.
•
Make sure that the tool is applied at a suitable place and does not slip when pushing down the
wishbone lever.
•
Always wear protective gloves when using the wishbone lever.
USE EXAMPLE
Loosen and remove clamping screws of the ball
joint bolt (A) or strut (B).
Position the hook (1) on the wishbone and the
support (2) on the front axle body.
Press the wishbone lever down.
Depending on which clamping screw has been
dismantled, either the ball joint separate from
the pivot bearing or the pivot bearing separate
from the strut.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Wishbone Lever
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3521
A
B
1
1
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
2