Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Read this manual before installing the product. In case of questions contact our technical
support: +55 (18) 3266-4050 or www.taramps.com.br.
At the end of its lifespan, this product must not be disposed of in household waste.
Look for an electronic equipment collection or recycling center for proper disposal.
Safety requirements
To ensure proper use, please read through this manual before using the product. It is specially
important that you know the WARNINGS and CAUTIONS contained here.
- The installation of this product must be done by a qualified professional.
- Use the correct tools for installing this product.
- This product is for use with 12V batteries. Always check the voltage before installing.
- This product must be installed in a firm place and away from heat sources.
- Never install the product in places exposed to dust, humidity and water. Pay attention to
install it far from fuel tank, fuel lines, heat sources and other parts of vehicle.
- Be sure to install protection fuse or a circuit braker near to battery. Follow the ampere rating
as indicated here in this manual. Use of improper fuse or circuit breaker could result in
overheat, smoke, damage to product, injury or burns.
- Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect
any wires routed through car's body.
- Automotive sound systems may produce high sound pressure levels. Avoid continuous
exposure to levels over 85dB to prevent permanent hearing loss.
Safety
As you read this manual, pay attention to the safety symbols.
This symbol with "CAUTION" is intended to alert the user to the presence
of important instructions. Failure to heed the instructions will result in risk
CAUTION
of injury to user or product damage.
Taramps reserves the right to modify the contents of this document at any time without prior notice and
does not have the obligation to apply the changes in units which were previously produced.
Declaration of Conformity
TARAMPS ELECTRONICS LTDA
Alfredo Marcondes - SP
Brazil
Hereby, Taramps Electronics Ltda declares that the product
EQ BASS complies with the Directive 2014/30/EU, according
with the following harmonized standard:
-EN 50498:2010
Electromagnetic compatibility (EMC) -
Product family standard for aftermarket
electronic equipment in vehicles
The full text of the EU Declaration of Conformity is available at
the Product Page on Internet.
06
Publicidad
