camry CR 2938 Manual De Uso página 4

17. Do not let the device or the power adapter get wet. Should the device fall into water, pull
the plug or power adapter out of the socket immediately. Do not immerse hands in water
when the device is connected to the mains power. In such a case, have the device checked
by a qualified electrician before using it again.
18.Never touch the device or the adapter with wet hands
19. Switch off the device after each use.
20. Do not leave the device or adapter unattended when connected to the power supply.
21. For additional protection, it is recommended to install the residual current device (RCD)
whose rated residual current does not exceed 30 mA. In this area, contact a specialist
electrician.
22. If the device needs to be equipped with a power adapter, do not cover it. Otherwise, it
can lead to a dangerous rise in temperature and damage to the device. First insert the plug
into the socket and then the adapter.
23. Charge the device in temperatures between 5°C and 35°C.
24. Before cleaning the shaver, always ensure that it is unplugged from the power source.
25. After charging the shaver , pull the charger from the power.
DESCRIPTION OF THE DEVICE (PIC. 1)
1. Blade head 2. Opening latch
5. USB C charging port.
HOW TO CHARGE
Before first use:
1. Plug in the device to an energy source via the USB C cable.
2. The red indicator light (3) will light to indicate the unit is charging.
3. Once charged, the light will stop blinking. Unplug the device.
4. Shaver can be used for approximately 7 days on a single charge.
DO NOT CHARGE FOR MORE THAN 20 CONSECUTIVE HOURS
TRAVEL LOCK:
TO lock and unlock:
1. Press the ON / OFF button for 3 seconds.
2. The charging indicator light will blink 3 times blue signaling the lock is active.
HOW TO USE
1. Press the ON/ Off button to turn the device on.
2. Begin shaving in the opposite direction of hair growth.
3. To achieve a closer shave, pull the skin taut with one hand while shaving with the other.
4. Press the ON/ Off button to turn the device off.
HOW TO CLEAN
1. First remove the protective blade cover as shown in picture 8 on page 2.
2. Using the cleaning brush provided, gently clean the foil and the cutter
4. The head can also be cleaned with water after each use as shown in picture 1 on page 2.
5. After cleaning, close the protective blade cutter.
6. After a dozen uses please add some machine oil to the blades. 1 drop per blade should be enough.
WARNING: Only the device head can be cleaned with water. DO NOT IMMERSE THE DEVICE IN WATER.
REPLACING AND CLEANING THE BLADE.
1. Open the blade compartment by following pictures 8 on page 2.
2. Remove the head bu pulling on the whole head and blades as shown on picture 10 on page 2.
3. Replace the head by pushing the metal plate into the device.
4. Place the new or cleaned blades back into their place and close the head.
TECHNICAL DATA:
Power: 2W
⎓
Charging: 5V 1A
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
3. On/Off Button 4. (Underside) Charging / Lock indicator light
DEUTSCH
4