Residual Risks; Electric Shock; Putting Into Operation; Using For The First Time - Exquisit WK6103 sw Manual De Instrucciones

7.4 Residual risks

DANGER

ELECTRIC SHOCK!

• Never touch the mains plug on the
mains power cable with wet or damp
hands when plugging it in or
unplugging it.
Do not carry out any work on the
•
appliance other than the cleaning

8 Putting into operation

Before opening, check the packaging for
damage.
ATTENTION
APPLIANCE DAMAGE!
Carefully open the packaging. Do not use
sharp knives or other pointed objects to
open the packaging.
Unpack the appliance as follows:
 Check if the delivery is complete.
 Check the appliance and the
individual parts for damage. If this
is the case, do not use the
appliance. Contact After Sales
Service. www.ggv-service.de

8.1 Using for the first time

Cleaning the appliance
1. Remove the packaging material and
all protective films.
2. Before using the appliance for the
first time, clean all parts of the
appliance as described in the
"Cleaning" section.
Setting up the appliance
Mount the appliance according to the figure
"Getting to know the appliance".
 Place the appliance in the middle of
a table out of reach of children.
 Place the appliance on a solid table;
do not use a soft base.
and service work described in this
instruction manual.
Remove the mains plug from the
•
plug socket before starting cleaning
or service work.
In an emergency, pull the mains
•
plug out of the plug socket
immediately.
Install and connect the appliance
•
only in accordance with the
description in the instruction
manual.
If the mains power cable or mains
•
plug is damaged, do not use the
appliance anymore.
Electrical connection
To ensure safe and fault-free operation of
the appliance, the following instructions
must be observed when making the
electrical connection:
 Before connecting the appliance,
compare the connection data
(voltage and frequency) on the type
plate with those of your electrical
network. This data must match to
prevent damage to the appliance. If
in doubt, contact a qualified
electrician.
 The socket must be protected by a
16A circuit breaker.
 If using an extension cable, it must
have a cross-section of 1.5mm².
 If you have a GS-approved 16 A
multiple socket strip, you must not
load it with more than 3680 watts
due to the risk of fire.

8.2 Operating the appliance

The kettle gets hot during operation and
hot steam escapes, so you may get burned
or scalded!
If the cover is not closed properly when
the kettle is turned on, the kettle cannot
turn off automatically and the hot water
may boil over.
EN
Page | 15