VONROC GP529AC Traducción Del Manual Original página 9

Switching on/off (Fig. A)
1. Check that the ON/OFF switch (1) of the pump
is in the 'O' position before connecting the
pressure switch to the power supply.
2. Move the ON/OFF switch (1) of the pump into
the position 'I' to switch the pump on. Open the
connected tap or spray gun. When you start the
pump, there will be a lot of air in the water first.
This is not a defect of your pump, but serves to
remove air from the pump. It may take several
minutes for the air to escape when the pump is
used for the first time.
3. When you close the connected tap or the spray
gun, the pump automatically stops pumping.
Now the pump is ready for use.
4. With the pressure switch (9) you can automati-
cally control the operation of the pump. When
you open the connected tap or the spray gun,
the pump automatically starts pumping. The
switch-on pressure is 1.4 bar.
5. When you close the connected tap or the spray
gun, the pump automatically stops pumping.
The switch-off pressure is 2.8 bar.
Reading the pressure (Fig. A)
The pipe pressure can be read on the pressure
gauge (10). The black scale indicates the pressure
in bar.
Finish operation (Fig. A, F)
Do not touch the pump unless its power has
been cut off for at least 5 minutes.
When there is the risk of frost or if you do
not use your pump for a long time, please
properly store your pump.
1. Check that the ON/OFF switch (1) is in the 'O'
position.
2. Remove the mains plug from the mains.
3. Unscrew and remove the drain plug (2). Let the
water drain.
4. Pull up the suction hose (be aware, it is full of
water).
5. Unscrew the suction hose (8) from the water
inlet (3).
6. Remove the filter and foot valve (4), then rinse
with clear water. Make sure that there is no
water left in the suction hose (8).
7. Remove the water hose from the water outlet (6).
Unscrew the coupling from the water outlet (6).
WWW.VONROC.COM
8. Place the drain plug (2) back, do not overtighten.
9. Clean and store the device (see 'Maintenance')
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Remove very
persistent dirt using a soft cloth moistened with
soapsuds. Do not use any solvents such as gasoli-
ne, alcohol, ammonia, etc. Chemicals such as these
will damage the synthetic components.
If the appliance appears to be blocked, switch off
the power at the mains, remove the plug from the
socket and check the appliance for blockages.
Clean suction hose, foot valve, pre-filter and pump.
Air pressure tank (Fig. G)
1. Check that the ON/OFF switch (1) is in the 'O'
position.
2. Remove the mains plug from the mains.
3. Open the connected tap or spray gun to reduce
the pressure.
4. Unscrew the pressure tank valve cap (12) from
the pressure tank valve (11).
5. Use an airgaug to check the air pressure, as
shown on figure E. It should be 1.5 until 1.8 bar.
6. If necessaire, pumping in or releasing air.
7. Place the pressure tank valve cap (12) back.
STORAGE AND FROST POTECTION
The garden pump and accessories that are not
completely drained can be destroyed by frost.
Completely drain the garden pump and accessories
and protect them against frost.
Keep this appliance in well-ventilated dry premises
with temperature not going below +5°C.
When not in use, keep this appliance stored in a
safe place out of reach of children.
EN
9