Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
Do not plug the power cord into a power outlet. Make
sure the plug is disconnected before assembling the
wet/dry vacuum. To reduce the risk of electric shock,
do not expose to rain.
UNPACKING YOUR WET/DRY VACUUM
See Figures 3-5.
• Verify that the power cord is disconnected from
the outlet.
• Undo the latches.
• Lift the power head off the collection tank.
• Remove the contents from inside the collection
tank; make sure you have all contents as listed
on page 5.
FIG. 3
FIG. 4
FIG. 5
ATTACHING THE CASTERS
See Figure 6.
• Turn the collection tank upside down and
insert the four caster feet into the slots on
the collection tank and tighten with supplied
screws. Verify that the casters are mounted
correctly. Do not over-tighten screws.
LATCH
1
2
POWER HEAD
6 English
ATTACHING THE HANDLE
See Figure 7.
• Attach the handle into the slots located on the
top of the power head and secure with supplied
screws.
INSTALLING THE CARTRIDGE FILTER
See Figures 8-9.
• Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not installed,
refer to page 13 for installation instructions.
FIG. 6
FIG. 7
FIG. 8
FIG. 9
CASTER FOOT
CARTRIDGE
FILTER
Publicidad
