Von Arx DTF 25 SH Instrucciones De Manejo página 6

DTF 25 SH • Operating Manual
Do not carry!
• For safety and health reasons, the heavy machines and their drums must not be transported
by hand.
Never leave a machine which is not in a safe state!
• Before leaving the machine, turn the motor off.
• Secure the machine by placing chocks under the wheels.
• Remove the mains plug or Interrupt the ignition contacts.
Do not remove protective devices!
• Only operate the machine when all the protective devices fitted in the factory are mounted
and in good working order.
Only use on horizontal surfaces!
• The shaver machine must only be used on horizontal surfaces.
• Make sure that the wheels rest firmly on the surface to be treated.
Do not misuse the electrical power cord!
• Do not use the cable to pull the plug out of the socket.
• Protect the cable against heat, oil and sharp edges.
• Lay the electric cable in such a way that it cannot be damaged by the working tools.
• In the open air, use only specially authorized and suitably marked extension cables.
• Use only electric cables with a suitable cross-section and the necessary length.
• Unroll the extension cable completely from the cable drum.
• Avoid bodily contacts with earthed parts.
Comply with the operating instructions of the electric motor manufacturer and the follow-
ing requirements!
• When not in use, make sure that the machine is disconnected from the power supply.
• Always pull out the plug when the machine is not being used.
• Modifications to the electrical wiring which may be prejudicial to safety or change the
original regulating and control functions are prohibited.
• Repairs to the electrical wiring may only be performed by a qualified electrician.
Do not remove guard devices!
• Damaged protection devices on machines must be professionally repaired or replaced by a
customer service workshop.
• Operate the machine only if all the guard devices mounted in the factory are in place and in
good working order!
• When work generates dust, always connect the vacuum cleaner system.
• Damaged dust aprons are prejudicial to the performance of the connected vacuum cleaner.
• Do not operate the machine unless the emergency stop switch is in working order.
• When working with the machine, always connect the fatigue switch ripcord to your wrist.
• Never work without the belt guard in place.
Operating location and workplace
When working with the machine, the machine operator will always stand behind the handlebar.
From this position, he can permanently monitor and, if necessary, correct the work to be per-
formed. Standing at this position, the machine operator can:
• Steer the machine
• Hold the machine back
• Actuate all the operating and control elements while the machine is in use.
• Machines with electrical or hydraulic drive must also be operated and controlled by the ma-
chine operator from this position.
6
Safety instructions