Publicidad
Idiomas disponibles
Idiomas disponibles
LumaPro Operating Instructions
Straight Arm Pole Mounting:
This fixture can be configured to provide 0 to 60° both upward and downward aiming in 15°
increments (see FIG.7).
• Connect the power lead properly, Make wiring connection (see WIRING) and lay the
wires in the pole, insert the Slipfitter to the pole(see FIG.8).
• Tighten the four M8 bolts on the slipfitter and secure it to the pole (see FIG.9).
• To aim the fixture, loosen and adjust the M12 knuckle bolt to right angle, adjust the aim
0 to 60°both upward and downward (see FIG.10).
• Inspect installation to ensure fixture is secure.
Maintenance
The unit is designed for years with minimum care. For optimum performance, periodically
clean lens with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or
cleaners containing abrasive agents. When cleaning the fixture, make sure you have the
power turned off and do not spray liquid cleaner directly onto the LED, or wiring.
Wiring
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the
power supply. All units must be individually connected to AC supply.
Note:
1. Verify that supply voltage is correct by comparing it to claimed voltage on the product
label.
2. All Wiring inside the fixture use WAGO connector of 5 PIN, 3 PIN and 2 PIN
(See FIG.13). If need to remove or replace any component in the driver compartment,
please keep the WAGO connector for future use.
436R33, 446M61, 446M57, 446M58
LED Area Light
Fixtures
5
Publicidad
